#1 Global Leader in Data Resilience

Can't delete replica when it is being processed.

KB ID: 2441
Product: Veeam Backup & Replication
Version: All
Published: 2018-02-02
Last Modified: 2023-04-12
mailbox
Get weekly article updates
By subscribing, you are agreeing to have your personal information managed in accordance with the terms of Veeam's Privacy Notice.

Cheers for trusting us with the spot in your mailbox!

Now you’re less likely to miss what’s been brewing in our knowledge base with this weekly digest

error icon

Oops! Something went wrong.

Please, try again later.

Challenge

Replication job fails with error:

Can't delete replica when it is being processed.

Cause

If a replication job failed before the replica VM is fully created, the job may fail attempting to delete the VM as part of an undo operation on the failed run.

Solution

This issue can generally be resolved by removing the reference to the replica out of Veeam and then mapping the replication job to use the existing partial replica.

Important: If you do not see a replica VM either in Veeam or in VMware, please create a new job.

The steps for doing this are below.
 

Part 1: Remove the Replica from configuration.

  1. Navigate to the replica in the “Ready” section under “Replicas”
  2. Right click the replica and click “Remove from configuration

    Note:
    Removing the replica from configuration will remove the source VM from the job as well. You will add this back to the job in the next step.

 

Part 2: Map the replication job to use the existing replica.

  1. Edit the Replication job.
  2. On the Name tab, select the option Replica seeding (for low bandwidth DR sites).
  3. On the Virtual Machines tab, click add and re-add the source VM back to the replication job.
  4. Continue clicking Next to reach the Seeding tab.
  5. On the Seeding tab, enable the option to Map replicas to existing VMs.
  6. In the Replica mapping list, select the original VM, and click “Edit…”, then select the existing replica.
  7. Continue clicking Next and finally Finish to save the job settings.
     

After doing this the job will need to calculate the digest, which can take an extended amount of time.


 

To submit feedback regarding this article, please click this link: Send Article Feedback
To report a typo on this page, highlight the typo with your mouse and press CTRL + Enter.

Spelling error in text

This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply except as noted in our Privacy Policy.
Thank you!

Thank you!

Your feedback has been received and will be reviewed.

Oops! Something went wrong.

Please, try again later.

You have selected too large block!

Please try select less.

KB Feedback/Suggestion

This form is only for KB Feedback/Suggestions, if you need help with the software open a support case

By submitting, you are agreeing to have your personal information managed in accordance with the terms of Veeam's Privacy Notice.
This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply except as noted in our Privacy Policy.
Verify your email to continue your product download
We've sent a verification code to:
  • Incorrect verification code. Please try again.
An email with a verification code was just sent to
Didn't receive the code? Click to resend in sec
Didn't receive the code? Click to resend
Thank you!

Thank you!

Your feedback has been received and will be reviewed.

error icon

Oops! Something went wrong.

Please, try again later.